Let your car drain the electrical system by holding down the brake pedal.

Jan 23, 2012 · class=" fc-falcon">75.

class=" fc-falcon">6 Answers.

I held the button down and it then turned off, I drove it around the block then parked it, and turned. .

Copy.

0 TDCI GHIA.

XCAL/SS 4-1/ORP/ AEM CAI / SH UDP/Ported. They tend to kink and they will throw your ABS light on. According to my mechanic, the sensor failure caused the ABS and 4WD lights to come on.

Faulty wheel speed sensors: ABS monitors the wheels’ speeds.

But if the BRAKE light / also comes on, it indicates a malfunction in the braking system and you must stop driving due to risk of brake failure. . .

. .

This computer module is located on top of the pump motor and is attached by four or five mounting bolts.

To clear the ABS light on a Ford Focus, first shut off the engine and then turn the key to the ‘on’ position without starting it.

Remember to click on the start button. Then pull the wheels away from the truck.

. Burning ABS and/or parking brake warning lights are a known problem of the Focus MK1.

I held the button down and it then turned off, I drove it around the block then parked it, and turned.
The vehicle can still be braked without ABS.
Just buy new ones, or splice them at the kink and use wire nuts and some tape to put them back together.

.

This computer module is located on top of the pump motor and is attached by four or five mounting bolts.

Mar 13, 2004 · class=" fc-falcon">I've got the same problem on a focus mk1 2002, I changed the cluster yesterday for one out of a 2004 model and now abs light and handbrake light is in constantly, they were never on with the old cluster just used to light up then go off. When the ABS light / comes on in your Focus, the anti-lock braking system is disabled. Nov 3, 2018 · The alternative is a faulty ABS Control Module.

com/pages/ford_code_readers__diagnostic_scan_reset_amp_tools_189128. . 1 Answer. Barring that, you should be able to reset the AdvanceTrac light by disconnecting the ground terminal of the battery. Connect the battery, turn the car on and drive. .

.

. be/5lgMhKYGuto.

The sensor was damaged by the drive shaft to the wheel.

Here is how you can get rid of the ABS light with an OBD2 scanner: Connect the OBD2 port on your scan tool with the OBD2 connector in your car.

be/5lgMhKYGuto.

.

Once it returns with the different fault codes, go back to the diagnostic menu and select erase codes.